Dynamic Cooking S y stems, Inc.The Professional Restaurant GasTandoorUse and Installation GuideModels:DCS-CGT
9Cleaning and MaintenanceGENERALNew units are wiped clean at the factory to remove any visible signs of dirt, oil, grease remaining from the man-ufa
10Parts ListITEM DESCRIPTION PART NO.1Manual Valve 3/8 130342 Knob Chrome 14020-023 Ceramic Bowl 142724 Logo DCS Medallion Series 173015 Leg Ass
11Troub les hootingThese troubleshooting procedures must be carried out only by a factory authorized agency for warranty repair.The problems and possi
12WarrantyFor warranty service, contact your local DCS authorized service agency. Provide him with the Model Number,Serial Number, and date of install
Part No. 17331Litho in USA 08/2000As product improvement is an ongoingprocess at DCS, we reserve the right tochange specifications or design withoutn
1A Message To Our CustomersFOR YOUR SAFETYDo not store or use gasoline or any otherflammable vapors and liquids in the vicinityof this or any other ap
2Introduction / S afety PrecautionsThank you for choosing your new Dynamic Cooking Systems Professional Restaurant Gas Tandoor. Our prod-ucts are de
3FeaturesThe Professional Tandoor by DCS comes with these standard features.● Input rating = 70,0000 BTU/HR● Overall dimensions 34” wide x 36” high x
4SpecificationsEXTERIOR DIMENSION● WIDTH: 34” (864mm) ● HEIGHT (w/6” legs): 36” (915mm) ● DEPTH: 35” (889mm)SHIPPING WEIGHT DIMENSIONS● MINIMUM ENT
5Pre-InstallationImportant:Safe and satisfactory operation of your equipment depends on its proper installation. Installation must conformto local co
UNPACKINGCheck that the container is upright. Use outward prying no hammering to remove the carton. Check theTandoor for visible damage. If such da
7Installing T he TandoorPRESSURE REGULATINGThe Tandoor and its individual shut-off valve must be disconnected from the gas supply piping system duri
8Initial Start-up / OperationPLACEMENT OF LAVA ROCKPlace a layer of lava rock on the stainless steel pan located directly above the burners.PILOT &
Comments to this Manuals