DCS CTD-304 Installation Guide download pdf (Page 10)

MOUNTING THE WALL OVENS

FIG. 4

L1 COMMON L2 GROUND

RED WHITE BLACK

Our built-in ovens require a dedicated and properly grounded 4-wire 120/240 volt, 60 Hz power supply, protected

by a time delay fuse or circuit breaker. Ovens are supplied with a flexible power cable which must be hard wired

to a junction box.

AMPERAGE:

■ WOT/WOTD-227& WOT/WOTD-230 = 50A

■ WOT-127& WOT-130 = 35A

WARNING !

Electrical Shock Hazard!! Follow these instructions!

CAUTION!

If the power leads are connected improperly (reversing L1 and N, or L2 and N (fig. 1), damage to the oven will result.

■ The electrical power to the oven branch circuit must be shut off while line connections are

being made.

■ Use the proper sized copper wiring only.

■ Electrical grounding is required on this appliance. The free end of the bare copper ground

wire must be connected to a suitable ground. This wire must remain grounded to the oven.

■ If cold water pipe is interrupted by plastic, non-metallic gaskets, union connections or other

insulating materials, Do Not use for grounding.

■ Do Not ground to a gas pipe.

■ Do Not have a fuse in the Neutral or Grounding circuit. This could result in an electrical shock!

■ If you are in any doubt as to whether the appliance is properly grounded, check with a

qualified electrician.

MOUNTING THE WALL OVEN:

WARNING:

Failure to follow these instruction could result in serious injury or death!

1 Remove all cardboard, packing materials, the bottom wood pallet and metal mounting brackets. Remove the oven

doors and oven racks (see Use & Care manual page 18).

2 After creating your precision cabinet cutout and supports, position the oven in front of the cutout. Make the

power supply connections as specified in this guide, and then slide the unit carefully into the cabinet opening.

3 When in place, drill 3/32” holes into cabinet frame through the mounting holes in the oven side trim. See fig. 2.

4 Secure oven to the cabinet with screws furnished as shown in figure 3 (uses 2 screws, 1 on each side, top oven

only).

5 Slip tabs on rear of bottom trim into mating slots in oven trim posts (see fig.4). Attach the bottom trim with the 2

screws provided.

FIG. 1

4-WIRE CONNECTIONS

FIG. 3

FIG. 2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

DCS CTD-304 Installation Guide Page 10