DCS RDU-305 Installation Guide download pdf (Page 21)

ELECTRICAL CONNECTIONS

ELECTRICAL CONNECTIONS  RGU & RGUC MODELS

The electrical supply must be a correctly polarized 120 volt AC, 60 Hz,

single phase circuit suitable for the maximum current draw of the model,

as detailed in the table below. Please verify your model’s current draw by

checking the rating label on the back of the range.

REQUIRED GROUNDING METHOD  RGU & RGUC

MODELS

This appliance is factory equipped with a power supply cord with a

three-prong grounding plug (with polarized parallel blades). It must be plugged into a mating grounding-type

receptacle, connected to a correctly polarized 120 volt circuit. If the circuit does not have a grounding type

receptacle, it is the responsibility and obligation of the installer to have the existing receptacle changed to a

properly grounded and polarized receptacle in accordance with all applicable local codes and ordinances by

a qualified electrician. In the absence of local codes and ordinances, the receptacle replacement shall be in

accordance with the National Electrical Code.

Note:

The third prong should not, under ANY circumstances, be cut or removed.

Receptacle Box

Cover Plate

Three Prong

Receptacle

Three

Prong

Plug

Fig. 15a Connecting the range to the power supply -

RGU & RGUC Models

BACKGUARD INSTALLATION

The backguard is located as shown in Fig. 14. Secure

the backguard to the range (standard backguards) or

the wall behind the range (full backguards). Specific

instructions for installation can be found packaged

with the backguard. See also “Planning The Instal-

lation” section. A backguard (standard or full) must

be installed when there is less than a 12” clearance

between combustibles and the back of the range

(above the cooking surface). See Fig. 13.

RGU and RGUC models are supplied with a standard

range mount backguard. For RDU models, DCS

backguards are sold separately.

Important!

Always disconnect electric

supply cord from the wall

outlet or service disconnect

before servicing this appliance.

Observe all governing codes and

ordinances when grounding,

in absence of which, observe

National Electrical Code ANSI /

NFPA No. 70.

Fig. 14

26-1/2"

3-1/2"

1-5/16"

11-13/32"

3-1/2"

13/16"

Wall Mount

Full Backguard

(BGRU-3030,

BGRU-3036,

BGRU-3048)

Range Mount

Standard

Backguard

(BGRU2-1530,

BGRU2-1536,

BGRU2-1548)

The rating label is located on the back

of the range

A wiring diagram label is attached to

the back of the range

Wiring diagrams

are also included in

the service

summary, attached

to the inside of the

kick panel

MODEL MAX. CURRENT DRAW CIRCUIT TO USE

RGU-305

5 amp 15 amp

RGU-364GD

8 amp 15 amp

RGU-364GL

8 amp 15 amp

RGU-366

5 amp 15 amp

RGU-484GG

15 amp 15 amp

RGU-485GD

15 amp 15 amp

RGU-486GD

12 amp 15 amp

RGU-486GL

12 amp 15 amp

RGUC-305

5 amp 15 amp

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Comments to this Manuals

No comments

DCS RDU-305 Installation Guide Page 21

Comments to this Manuals

Related products and manuals for Cookers DCS RDU-305