DCS BGS-1248 Installation Guide Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 27
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
ELECTRICAL CONNECTIONS
17
ELECTRICAL CONNECTIONS
Power Requirements Range:
120 VAC, 60 Hz., single phase
RGT-305: 4 Amp. Max.
RGT-36: 7 Amp. Max.
RGT-48: 13 Amp. Max.
Always disconnect electric supply cord from the wall outlet or service
disc
onnec
t before servicing this appliance. Observe all governing codes
and ordinances when grounding, in absence of which, observe National
Electrical Code ANSI / NFPA No. 70.
RECOMMENDED GROUNDING METHOD
T
his applianc
e is factory equipped with a power supply cord with a
thr
ee
-pr
ong g
r
ounding plug (with polarized parallel blades). It must be
plugged into a mating grounding, type receptacle, connected to a
c
orrectly polarized 120 volt circuit. If the circuit does not have a grounding type receptacle, it is the responsi-
bilit
y and obliga
tion of the installer t
o ha
v
e the existing receptacle changed to a properly grounded and
polarized receptacle in accordance with all applicable local codes and ordinances by a qualified electrician. In
the absenc
e of local codes and ordinances, the receptacle replacement shall be in accordance with the National
Elec
trical Code
.
Note:
The third prong should not, under ANY circumstances, be cut or removed.
Receptacle Box
Cover Plate
Three Prong
Receptacle
Three
Prong
Plug
F
ig
. 15
BACKGUARD INSTALLATION
T
he backguard is located as shown in Fig. 14. Secure
the backguard to the wall behind the range. Specific
instructions for installation of the full backguard or low
backguard can be found packaged with the backguard.
See also page 8, “Planning The Installation section. A
b
ackguard must be installed when there is less than a
12” clearance between combustibles and the back of
the range (above the cooking surface). See fig. 13.
DCS backguards are sold separately.
Fig. 14
28-1/8"
10-1/8"
2"
1-5/16"
W
all Mount
Full Backguard
(
Model #’s BGS-3030,
B
GS-3036, BGS-3048)
Wall Mount
Low Backguard
(Model #’s BGS-1230,
B
GS-1236, BGS-1248)
}
use 15 Amp. circuit
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Comments to this Manuals

No comments