DCS WOSU-30 User's Guide download pdf

WARNING!

Electrical hazard

Always disconnect the oven from

the mains electricity supply

before carrying out any

maintenance operations or

repairs.

Failure to do so may result in

electrical shock or death.

Important safety precautions!

Save these instructions for the local inspectors’ use.

To avoid hazard, follow these instructions carefully before installing or using this product.

Please make this information available to the person installing the product as it could reduce your

installation costs.

This oven is to be installed and connected to the electricity supply only by an authorized person.

If the installation requires alterations to the domestic electrical system, call a qualified electrician. The

electrician should also check that the socket cable section is suitable for the electricity drawn by the oven.

The oven must be grounded.

To connect the oven to the mains, do not use adapters, reducers or branching devices as they can cause

overheating and burning.

Installation must comply with your local building and electricity regulations.

Failure to install the oven correctly could invalidate any warranty or liability claims.

Important!

SAVE THESE INSTRUCTIONS

The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go to our website

www.dcsappliances.com or contact your local DCS Customer Care Representative.

SAFETY AND WARNINGS

WARNING!

Cut hazard

Take care - panel edges are sharp.

Failure to use caution could result in injury or cuts.

Before you install the oven, please make sure that

The oven will rest on a surface that can support its weight.

The countertop and oven cavity are square and level, and are the required dimensions.

The height from the floor suits the user.

The oven door can open fully without obstruction.

Electrical requirements

Connect oven with copper wire only.

Do not cut the conduit.

A U.L. listed conduit connector must be provided at the junction box.

Do not ground to a gas pipe.

Do not have a fuse in the grounding or neutral circuit.

Fuse both sides of the line.

A time delay fuse or circuit breaker is recommended. If using a time delay fuse, then fuse both sides of the

line.

Flexible armored cable from the appliance should be connected directly to the junction box.

Connect directly to the fused disconnect (or circuit breaker box) through flexible, armored or non-metallic

sheathed, copper cable (with grounding wire).

If codes permit and a separate grounding wire is used, it is recommended that a qualified electrician

determine that the grounding path and wire gauge are in accordance with local codes.

Do not use an extension cord with this appliance.

When you install the oven

Do not seal the oven into the cabinetry with silicone or glue. This makes future servicing difficult. Fisher &

Paykel will not cover the costs of removing the oven, or of damage caused by this removal.

Use the supplied screws to secure the oven to the cabinetry. Do not over-tighten the screws.

Do not stand on the door, or place heavy objects on it.

Do not lift the oven by the door handle.

Take extra care not to damage the lower trim of the oven.

Wall oven

Installation instructions

WOU130,WOSU30, WOUD230,WODU30 models

US CA

409 lb

186 kg

242 lb

110 kg

WARNING!

Very Heavy

Do not attempt to lift this

product unassisted.

Lifting unassisted may

cause serious injury.

SINGLE

OVEN

MODELS

DOUBLE

OVEN

MODELS

(1,1) -1- 599990A DCSWOU130&WOUD230install A2 USCA.indd 12/2/10 11:00:52 AM

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Installation instructions

WARNING! Electrical hazard Always disconnect the oven from the mains electricity supply before carrying out any maintenance operations or repai

Page 2 - (inches (mm))

2PRODUCT AND CABINETRY DIMENSIONSDouble oven modelsSingle oven modelsABCEDFGHJKProduct and cabinetry dimensions (inches (mm))WOU130WOSU30modelsAoveral

Page 3

1144231A4UNPACK THE OVEN AND REMOVE THE DOOR(S)BDouble models featured for illustration purposes onlyJunction box location for: undercounter installat

Page 4 - Important!

6pj1121112243Shelf tagGuard railSliding frame(push fully into place)SECURE THE OVEN TO THE CABINETRY AND REFIT THE DOOR(S)A BTake care not to damage t

Page 5 - Instructions d’installation

MISE EN GARDE! Risque de chocs électriques Débranchez toujours l’alimentation principale du four avant d’effectuer tout service d’entretien ou to

Page 6 - (po [mm])

2DIMENSIONS DE L’APPAREIL ET DU MODULEModèles de four doublesModèles de four simplesABCEDFGHJKDimensions de l’appareil et du module (po [mm])ModèlesWO

Page 7

1144231A4DÉBALLEZ LE FOUR ET RETIREZ LES PORTESBModèles doubles montrés à titre indicatif seulementEmplacement de la boîte de jonction pour une instal

Page 8 - LISTE DE VÉRIFICATION FINALE

61121112243Shelf tagGuard railSliding frame(push fully into place)FIXEZ LE FOUR AU MODULE, PUIS REMETTEZ LES PORTES EN PLACEA BAssurez-vous de ne pas