DCS CMOTTK30 User Manual download pdf

MODEL CMOTTK30 CONVECTION MICROWAVE TRIM KIT

INSTALLATION INSTRUCTIONS

Before installing trim kit, install the convection duct as follows:

1. Insert the rear section of the duct into the forward section of the duct and install 4 screws supplied

(Fig. 01).

2. Install foam tape on 2 flanges of the rear section of the duct (Fig. 02).

3. Remove and retain the 2 top screws, left and right, located at the rear vertical edges of the Microwave

(Fig. 03).

4. Place the duct on top of the Microwave and reinsert the 2 screws removed in Step 3 (Fig. 04).

Before you begin, read these instructions completely and carefully.

Getting Started

■ Remove packaging

Contents Tools Required

Part Description Qty

Trim Assembly 1

Base 1

Rear Duct 1

Forward Duct 1

Foam Tape 2 ft

Mounting Bracket (L/R) 2

Sheet Metal Screws 14

1/8” Drill

#2 Phillip Screwdriver

Fig. 01

Fig. 02

Fig. 03

Fig. 04

4 Screws

Foam Tape

Foam

Tape

1 2 3 4

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

MODEL CMOTTK30 CONVECTION MICROWAVE TRIM KITINSTALLATION INSTRUCTIONS Before installing trim kit, install the convection duct as follows:1. Insert the

Page 2 - Installing Trim Kit

Installing Trim Kit1. Cut opening in the cabinet face per the following dimensions:Height: 19-3/16” + 1/16”, –0Width: 25-3/4” + 1/16”, –0Note: Refer t

Page 3 - Stainless Steel Care

Stainless Steel CareThis Trim Kit is made of stainless steel. Use the mildest cleaning procedure first. Start with hot soapy water,rinse and dry. I

Page 4 - P/N 241185 Rev. A 10/07

5800 Skylab Road, Huntington Beach, CA 92647 Tel: 714.372.7000 • Fax: 714.372.7001 Customer Service: 888.281.5698www.dcsappliances.c