DCS RF24D Service Manual download pdf (Page 16)

4.1 GAINING ACCESS TO MECHANICAL BASEPLATE

The mechanical baseplate is located in the rear of the unit. Most major mechanical and electrical components on the

unit mount directly to the baseplate. This creates easy access for servicing of the sealed system and mechanical/electri-

cal components. To gain access to the mechanical baseplate, remove the screws that hold the lower shroud in place

and then remove the shroud (see Figure 4.1). To facilitate working on any component mounted to the mechanical base,

remove the screws that hold the baseplate to the chair frame and slide out the baseplate enough to allow working room

required (see Figures 4.2 and 4.3).

Figure 4.1

Remove screws.

Figure 4.2

Remove screws securing

the mechanical baseplate.

Figure 4.3

Slide out the mechanical

baseplate.

SEALED SYSTEM COMPONENTS

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

No comments

DCS RF24D Service Manual Page 16