Dcs RDT-305 User Manual download pdf (Page 10)

PLANNING THE INSTALLATION

IMPORTANT INSTALLATION INFORMATION

he RDT is tested in accordance with ANSI Z21.1 Standard for Household Cooking Gas Appliances.

The range must be installed in conjunction with a suitable overhead vent hood. (See ventilation requirements,

age 12). Due to the professional high heat capacity of this unit, particular attention should be paid to the hood

and duct work installation to ensure it meets local building codes. To eliminate risk of burns or fire by reaching

over heated surface units, cabinet storage located above the surface units should be avoided.

All range models with less than a 12” clearance between combustible material and the back edge of the range,

require the installation of one of the two offered Wall Mount Backguards – see page 17.

Check local building codes for the proper method of range installation. Local codes vary. Installation, electrical

connections, and grounding must comply with all applicable codes. In the absence of local codes, the range /

cooktop should be installed in accordance with the National Fuel Gas Code ANSI Z223.1 and National Electrical

Code ANSI / NFPA 70.

Be sure that the unit being installed is set up for the kind of gas being used. The gas range is shipped from the

factory set and adjusted for Natural Gas or LP (propane), depending on the specific model ordered. V

erify that

the range is c

ompa

tible with the gas t

ype a

t the installation site before proceeding further.

Return range

to dealer if the unit is not set for the gas supplied at the site.

FIG. 1

All Ranges are shipped with a standard 2”

integral island trim.

28-1/8”

10-1/8”

Wall Mount Full

Backguard

Wall Mount

Low Backguard

1-5/16”

Model Number

Low

Backguard

Full

Backguard

48” Range BGS-1248 BGS-3048

36” Range BGS-1236 BGS-3036

30” Range BGS-1230 BGS-3030

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

No comments

Dcs RDT-305 User Manual Page 10