DCS ADR24 Operations Instructions download pdf (Page 65)

VEGASON 51P … 53P 65

Setup

6.3 Sensor adjustment with the ad-

justment module MINICOM

-

+

ESC

OK

Tank 1

m (d)

12.345

In addition to the PC, you can adjust the

sensors with the small, detachable adjust-

ment module MINICOM directly in the sensor.

With the adjustment module MINICOM, only

the sensor-relevant adjustment such as e.g.

scaling of the sensor display, operating

range, meas. conditions, sensor display

scaling or false echo storage are possible.

However, not possible are all adjustment

steps relating to configuration, conditioning

and signal processing (configuration of the

inputs and outputs, linearisation curves,

simulation …). This is only possible with the

PC.

The adjustment module MINICOM is adjusted

with six keys. A small display shows you,

apart from the measured value, a short mes-

sage on the menu item or the entered value

of a menu adjustment.

The volume of information of the small display,

however, cannot be compared with that of the

adjustment program VVO, but with the help

of the menu schematic for MINICOM, you will

quickly find your way through the adjustment

structure. In time, you might even be able to

carry out your adjustments with the small

module faster and more efficiently than with

the PC.

Error codes:

E013 No valid measured value

- Sensor in the warm-up phase

- Loss of the useful echo

E017 Adjustment span too small

E036 Sensor program not operating

- Sensor must be reprogrammed

(service)

- Fault signal also appears during

programming

E040 Hardware failure, electronics

defective

Adjustment steps

On pages 70 and 71 you will find the com-

plete menu schematic of the adjustment mod-

ule MINICOM.

Set up the sensor in the numbered se-

quence:

1. Address

2. Measurement in gases

3. Operating range

4. Adjustment

5. Conditioning

6. Meas. conditions

7. False echo storage (only required when

errors occur during operation).

8. Indication of the useful and noise level

9. Outputs

Short explanations to the setup steps 1 … 9

follow.

1. Address

Choose a free bus address with the DIP

switch (see chapter "5.2 Sensor address“).

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 83 84

Comments to this Manuals

No comments