DCS RGSC-305 Specifications download pdf (Page 9)

UNPACKING AND HANDUNG

LevelingLegs

Range blust

be Uniformly

Supported

on E_Faces

22"

FIG. 9

To remove the door, open the door and

hoHd it aH the way open. CHose the

hinge Hatches (See Fig. 10) and reHease

the door. The door can then be

removed by gently lifting and pulling

the door, with the hinges up and out of

the frame.

The professionaH range shouHd be

transported by a dolly chose to its finaH

Hocation. The range can be tipped back

and supported on the rear Hegs while

the dolly is removed. The floor under

the legs should be protected (wood

strips, carpet, paneming,etc°) before

pushing the unit back into position.

E[ectdc and gas connections should be

made (Steps 4,5 & 6),the anti-tip device

installed (Step 7), and the backguard

installed (Step 8) before the range usplaced in its final position. Hfthe unit is to be converted to LPgas,

it can be done with the range in place (See page 10).

For proper performance, the professional range should be [eve[. To achieve a flush fit of the range to

adjoinin 9 countertops, it will be necessary to have level cabinets (front to back, and left to right across

the opening of the range). After checking the countertops for level and before sliding the range into

place, measure the distance from the floor to

the top of the counter work surface in the

rear left and right corners. Adjust the

corresponding rear corner of the range to an

equal height of the counter, as the rear

leveling legs are not accessible once the

range is pushed into place. Once the range

is in place, the front leg levelers can be

accessed to level the front of the range.

Replace the kick panel and oven doors by

reversing the procedure described

previously, it is important that the two

screws retaining the kick panel are secure

to prevent accidental access to live

emectrical components and wires (See Fig.

6, page 7},

NOTE: For ease of installation, be sure to

install vent hood and backguard

system before sliding range into

position.

DOOR HINGI ROLLER

UN-LOCK

FIG. 10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

Comments to this Manuals

No comments

DCS RGSC-305 Specifications Page 9

Comments to this Manuals

Related products and manuals for Cookers DCS RGSC-305