DCS CS-484GG User Manual download pdf (Page 27)

CARE AND MAINTENANCE

Follow the manufacturer's directions. Commerda[ oven cleaners are corrosive to the thermostat bulb

and infrared broiler burner. Do not spray or wipe this type cleaner onto the oven thermostat bulb (#9

& #25 pg. 28 & 29) or broiler burner. If some cleaner gets onto the bulb or broiler burner, wipe it off

immediately with a dean damp cloth.

BACKGUARD

This is made of stainless steel Use the mi[dest cleaning procedure first. Hot soapy water, rinse and dry.

If the pane[ has food soil remaining, try a genera[ kitchen cleaner, such as Fantastik _, Simple Green ° or

Formula 409_L For hard to dean soil use a stainless steel cleaner such as, Bon-Ami, Cameo _, or Bar

Keepers Friend. Apply cleaner with a damp sponge, rinse thoroughly and dry. Always scrub lightly in

the direction of the grain. Do not use a steel woo[ pad, it will scratch the surface. To touch up

noticeable scratches in the stainless steel, sand very lightly with dry 100 grit emery paper, rubbing in

the direction of the grain. After cleaning use a stainless steel polish, such as Stainless Steel Magic_]f

the rear top burners are used extensively on high it is possible for the vertical stainless steel pane[ to

discolor from the burner heat. This discoloration can be removed by using Revere Ware Stainless Steel

Cleaner.

OVEN RACKS AND RACK SUPPORTS

The oven racks and [adder racks are chrome plated steel Chrome cleaners, such as Soft Scrub, Cameo

or Bar Keepers Friend can be applied with a damp sponge following package directions. Rinse and dry.

Powdered cleaners such as Bon-Ami or Comet are applied with a damp sponge or cloth, rubbed lightly,

rinsed and dried. For hard to remove food soil use a dampened soap filled steel wool pad, rinse and dry.

Harsh Cleaners which are commercial oven cleaners, such as Easy Offor Dow can be used on the racks.

However, some commercial oven cleaners cause darkening and discoloration.Test the cleaner on a

small pa rt of the rack and check for an}, discoloration before clea ning the entire rack. Apply a generous

coating. Allow to stand for 15 to 20 minutes. Rinse thoroughly and dry. After being cleaned, if the racks

do not slide easily, pour a small amount of cooking oil on a paper towel and rub it lightly over the side

raHs.

FRAME, SIDES, DOOR EXTERIOR, HEAT DEFLECTOR

These parts are made of stainless steel, follow the directions for the Backguard (above). Take care when

cleaning the door top, and do not let water or cleaners run down the vents. If water or cleaners spill

into the vents, they may streak the glass inside the door.

DOOR GASKET

Use warm soapy water and rub softly, blot dry with a cloth. Do not rub. Do not remove or damage the

mesh.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34

No comments

DCS CS-484GG User Manual Page 27