DCS WDU models Specifications download pdf (Page 155)

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

3.5.5.4. Message Sending And Writing

3.5.5.4.1. Send Message - +CMGS

+CMGS - Send Message

(PDU Mode)

AT+CMGS=

(PDU Mode)

Execution command sends to the network a message.

Parameter:

<length> - length of the PDU to be sent in bytes (excluding the SMSC

address octets).

7..164

After command line is terminated with <CR>, the device responds sending a

four character sequence prompt:

<CR><LF><greater_than><space> (IRA 13, 10, 62, 32)

and waits for the specified number of bytes.

Note: the DCD signal shall be in ON state while PDU is given.

Note: the echoing of given characters back from the TA is controlled by

echo command E

Note: the PDU shall be hexadecimal format (each octet of the PDU is given

as two IRA character long hexadecimal number) and given in one line.

Note: when the length octet of the SMSC address (given in the PDU) equals

zero, the SMSC address set with command +CSCA is used; in this case the

SMSC Type-of-Address octet shall not be present in the PDU.

To send the message issue Ctrl-Z char (0x1A hex).

To exit without sending the message issue ESC char (0x1B hex).

If message is successfully sent to the network, then the result is sent in the

format:

Note : Optionally (when +CSMS <service> value is 1 and network supports)

<scts> is returned:

+CMGS: <mr>[, <scts>]

where

<mr> - message reference number.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 317 318

No comments

DCS WDU models Specifications Page 155