DCS WDU models Specifications download pdf (Page 231)

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

[,<detGPIO>

[,<repGPIO>]]]]

0 - detection algorithm not active

1 - detection algorithm active; detection is started every <interval> period,

using <detGPIO> for detection.

2 - triggers the new measurement of the antenna presence, reporting the

result in the format:

#GSMAD: <presence>

where:

0 - antenna connected.

1 - antenna connector short circuited to ground.

2 - antenna connector short circuited to power.

3 - antenna not detected (open).

<urcmode> - URC presentation mode. It has meaning only if <mod> is 1.

0 - it disables the presentation of the antenna detection URC

1 - it enables the presentation of the antenna detection URC, whenever the

antenna detection algorithm detects a change in the antenna status; the

unsolicited message is in the format:

#GSMAD: <presence>

where:

<presence> is as before

<interval> - duration in seconds of the interval between two consecutive

antenna detection algorithm runs (default is 120). It has

meaning only if <mod> is 1.

1..3600 - seconds

<detGPIO> - defines which GPIO shall be used as input by the Antenna

Detection algorithm (default 13)..

Valid range

is “any input pin number” (see “Hardware User Guide”).

<repGPIO> - defines which GPIO shall be used by the Antenna Detection

algorithm to report antenna condition. Value 0 means that no

report is made using GPIO (default 0). It has meaning only if

<mod> is 1.

0 - no report is made using GPIO

Valid range

is “any output pin number” (see “Hardware User Guide”).

Note: last <urcmode> settings are saved as extended profile parameters.

Note: GPIO is set to LOW when antenna is connected. Set to HIGH otherwise

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 317 318

No comments

DCS WDU models Specifications Page 231