DCS WDU models Specifications download pdf (Page 93)

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

3.5.4.4. Mobile Equipment Control

3.5.4.4.1. Phone Activity Status - +CPAS

+CPAS - Phone Activity Status

AT+CPAS Execution command reports the device status in the form:

+CPAS: <pas>

Where:

<pas> - phone activity status

0 - ready (device allows commands from TA/TE)

1 - unavailable (device does not allow commands from TA/TE)

2 - unknown (device is not guaranteed to respond to instructions)

3 - ringing (device is ready for commands from TA/TE, but the ringer is

active)

4 - call in progress (device is ready for commands from TA/TE, but a call is

in progress)

AT+CPAS=? Test command reports the supported range of values for <pas>.

Note: although +CPAS is an execution command, 3gpp TS 27.007 requires

the Test command to be defined.

Example

ATD03282131321;

AT+CPAS

+CPAS: 4

the called phone has answered to your call

ATH

Reference 3GPP TS 27.007

3.5.4.4.2. Set Phone Functionality - +CFUN

+CFUN - Set Phone Functionality

AT+CFUN=

[<fun>[,<rst>]]

Set command selects the level of functionality in the ME.

Parameters:

<fun> - is the power saving function mode

0 - minimum functionality, NON-CYCLIC SLEEP mode: in this mode, the AT

interface is not accessible. Consequently, once you have set <fun> level

0, do not send further characters. Otherwise these characters remain in

the input buffer and may delay the output of an unsolicited result code.

The first wake-up event stops power saving and takes the ME back to full

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 317 318

No comments

DCS WDU models Specifications Page 93