DCS WDU models Specifications download pdf (Page 278)

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

#EPASSW - E-mail Authentication Password

empty "".

AT#EPASSW=? Test command returns the maximum allowed length of the string

parameter <e-pwd>.

Example AT#EPASSW="myPassword"

Note It is a different password field than the one used for GPRS authentication

(see #PASSW).

3.5.7.5.5. E-mail Sending With GPRS Context Activation

- #SEMAIL

#SEMAIL - E-mail Sending With GPRS Context Activation

AT#SEMAIL=

[<da>,<subj>

]

Execution command activates a GPRS context, if not previously activated

by #EMAILACT, and sends an e-mail message. The GPRS context is

deactivated when the e-mail is sent.

Parameters:

<da> - destination address, string type.

<subj> - subject of the message, string type.

The device responds to the command with the prompt '>' and awaits for

the message body text.

To complete the operation send Ctrl-Z char (0x1A hex); to exit without

writing the message send ESC char (0x1B hex).

If e-mail message is successfully sent, then the response is OK.

If message sending fails for some reason, an error code is reported

Note: Care must be taken to ensure that during the command execution,

no other commands are issued.

To avoid malfunctions is suggested to wait for the OK or ERROR / +CMS

ERROR:<err> response before issuing further commands.

AT#SEMAIL=? Test command returns the OK result code.

Example AT#SEMAIL="[email protected]","subject of the mail"

>message body… this is the text of the mail message…

CTRL-Z

..wait..

Message has been sent.

Note This command is obsolete. It’s suggested to use the couple #EMAILACT and

1 2 ... 273 274 275 276 277 278 279 280 281 282 283 ... 317 318

No comments

DCS WDU models Specifications Page 278