DCS WDU models Specifications Page 156

  • Download
  • Add to my manuals
  • Print
  • Page
    / 318
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 155
UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 156 of 318
+CMGS - Send Message
<scts> - TP-Service Centre Time Stamp in Time String Format.
Note: if message sending fails for some reason, an error code is reported.
Note: care must be taken to ensure that during the command execution,
which may take several seconds, no other SIM interacting commands are
issued.
(Text Mode)
AT+CMGS=<da>
[,<toda>]
(Text Mode)
Execution command sends to the network a message.
Parameters:
<da> - destination address, string type represented in the currently
selected character set (see +CSCS).
<toda> - type of destination address
129 - number in national format
145 - number in international format (contains the "+")
After command line is terminated with <CR>, the device responds sending a
four character sequence prompt:
<CR><LF><greater_than><space> (IRA 13, 10, 62, 32)
After this prompt text can be entered; the entered text should be formatted
as follows:
- if current <dcs> (see +CSMP) indicates that GSM03.38/23.038 default
alphabet is used and current <fo> (see +CSMP) indicates that 3GPP TS
03.40/23.040 TP-User-Data-Header-Indication is not set, then ME/TA
converts the entered text into GSM/WCDMA alphabet, according to 3GPP
TS 27.005, Annex A; backspace can be used to delete last character and
carriage returns can be used.
- if current <dcs> (see +CSMP) indicates that 8-bit or UCS2 data coding
scheme is used or current <fo> (see +CSMP) indicates that 3GPP TS
03.40/23.040 TP-User-Data-Header-Indication is set, the entered text
should consist of two IRA character long hexadecimal numbers which
ME/TA converts into 8-bit octet (e.g. the ‘asterisk’ will be entered as 2A
(IRA50 and IRA65) and this will be converted to an octet with integer value
0x2A)
Note: the DCD signal shall be in ON state while text is entered.
Note: the echoing of entered characters back from the TA is controlled by
echo command E
Page view 155
1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 317 318

Comments to this Manuals

No comments